Grab & Go Garland Installation Guide

Thank you for choosing Creating Memories By Connie!
Our Grab & Go garlands are designed to give you a beautiful, professional-looking balloon setup with a simple, easy installation process. With just a few steps, you can transform your space and create a stunning display for your celebration.

Follow the instructions below to ensure your garland is securely installed and looks its best.

What’s Included in Your Kit

4 Command™ mini hooks (each with a 260 balloon attached)
(Only 3 hooks are needed for installation — top, center, and bottom)
6 alcohol pads
5 adhesive strips

Installation Instructions

Step 1: Prepare the Surface

Use an alcohol pad to clean the area where each hook will be placed. This removes dust and residue, helping the hooks adhere properly.

Allow the surface to dry completely.

Step 2: Apply the Hooks

Peel the colored side (red/blue) of the adhesive strip and attach it to the back of the Command hook.
Press firmly and hold for about 30 seconds to secure it.

Place each hook on the wall at a slight upward angle, positioning them where you want your garland to sit (top, center, and bottom).
Repeat for the remaining hooks.

Step 3: Attach the Garland

Take the attached 260 balloon and wrap it around two balloons on the garland.
Tie it securely in the center of the garland twice to hold it in place.

Repeat this step for each hook until your garland is fully secured.